Popps Posted September 21, 2015 Share Posted September 21, 2015 Why can't I programme my R8247 accessory decoder. I have the hornby e link. Link to comment Share on other sites More sharing options...
RDS Posted September 21, 2015 Share Posted September 21, 2015 Hi Popps and welcome to the forum. I think you will need to be a little more specific though with your question. There are some great guys on here who will be able to help you but it is essential really to try to specify what you have done so far. Link to comment Share on other sites More sharing options...
Fishmanoz Posted September 21, 2015 Share Posted September 21, 2015 You could start by following th instructions in the RM manual rather than the 8247 leaflet, then tell us where it goes wrong. Two fundamentals there are that you have to connect it to the programming track to do it and you have to understand and use group addressing. That's all in the Manual. Link to comment Share on other sites More sharing options...
2e0dtoeric Posted September 22, 2015 Share Posted September 22, 2015 This would also be better in the Elink threads! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.