Jump to content

Railmaster uses link to controller after set up


richardp

Recommended Posts

Posted

I am running windows 7 and updated railmaster yesterday. It opens ok and sets points but then says connection us list due to short circuit or USB connections. Both of these are ok. Does anyone gave any advice?

Posted

Hi Richard - there is plenty on this subject in the Railmaster thread. Have a wander over there, your answer awaits. R-

Posted

Richard,

Your issue is a well documented one. As Roger says, there are many varied threads on the subject all over this forum site, not just the Railmaster section. The most informative is this one. Fifth post down on page 1 of the thread made by HRMS. You need to follow ALL steps suggested, but pay particular attention to the need to add two extra lines to your railmaster.ini file. Adding these two lines correctly will prevent the popups you have described.

.

Review page 33 of your 1.63 manual for instructions on how to access and edit your .INI file.

Archived

This topic is now archived and is closed to further replies.

×
  • Create New...