geoffb41 Posted October 18, 2016 Share Posted October 18, 2016 just starting up again after a break and i've forgotten how to change the display so you have two columns of your locos in the display windowappreciate if someone could advise geoff b Link to comment Share on other sites More sharing options...
NormanQ4 Posted October 18, 2016 Share Posted October 18, 2016 Click gear wheel in top left of RM screen for system settings.Go to bottom left section of display. Link to comment Share on other sites More sharing options...
geoffb41 Posted October 18, 2016 Author Share Posted October 18, 2016 thanks yr reply but under settings have general & loco detection tabs but nothing there for display Link to comment Share on other sites More sharing options...
NormanQ4 Posted October 18, 2016 Share Posted October 18, 2016 In the general tab :-Loco control area number across - select 0,1 or 2 Link to comment Share on other sites More sharing options...
96RAF Posted October 18, 2016 Share Posted October 18, 2016 thanks yr reply but under settings have general & loco detection tabs but nothing there for displayPage 23 of the manual and as shown here. /media/tinymce_upload/6c83ae20e0f93973fa41b500fcb05bbf.PNG Link to comment Share on other sites More sharing options...
geoffb41 Posted October 18, 2016 Author Share Posted October 18, 2016 ok got it thanks Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.