bigfeet Posted August 4, 2017 Share Posted August 4, 2017 Where do I connect the module and where should isolating joints be? Link to comment Share on other sites More sharing options...
Chrissaf Posted August 4, 2017 Share Posted August 4, 2017 See this previous reply of mine. 6th post down from the top and five posts up from the bottom on the page linked below. OK, this reply post originally written for a DC user. For DCC, just replace the DPDT switch with an electronic DCC RLM to perform the same automatic switching function. The Insulated Rail Joiner (IRJ) positions will most likely be same..https://www.hornby.com/uk-en/forum/layout-advice-please/?p=1 Link to comment Share on other sites More sharing options...
bigfeet Posted August 4, 2017 Author Share Posted August 4, 2017 Many thanks, I will have a look and give it a go Link to comment Share on other sites More sharing options...
Chrissaf Posted August 4, 2017 Share Posted August 4, 2017 If you post a schematic drawing showing your layout track design, then a specific tailored answer can be given to you. Use the 'black & white hill and moon landscape icon' to post a .JPG image. Note that any posted image will be held back for checking by the site administrator (Mon to Fri office hours) and may not appear in the forum before Monday. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.