alan_french Posted September 2, 2017 Share Posted September 2, 2017 can anybody tell me how to set up a hornby tts sound in my tornado using a gaugmaster controller. please i need start voltage / acceleration rate / deceleration rate/ top voltage.thanks Alan Link to comment Share on other sites More sharing options...
Howbi Posted September 2, 2017 Share Posted September 2, 2017 Alan.........full instructions come with the decoder........all the CVs are listed with default values and available range values so you can set your own if desired........when you say Gaugemaster controller I assume you mean the Prodigy?..........HB Link to comment Share on other sites More sharing options...
jane1707819582 Posted September 2, 2017 Share Posted September 2, 2017 start voltage and top voltage are not supported on the tts decoder cv 3 and cv 4 sould be set at a value higher than 15 as guagemaster do several dcc controllers ,i will need more info Link to comment Share on other sites More sharing options...
Nick_ Posted September 3, 2017 Share Posted September 3, 2017 Do the TT decoders only support the same sub-set of CVs as the R8429 decoders (plus the sound functionality) or are they more fully featured like the Sapphire snd other manufacturers decoders? Link to comment Share on other sites More sharing options...
jane1707819582 Posted September 3, 2017 Share Posted September 3, 2017 Do the TT decoders only support the same sub-set of CVs as the R8429 decoders (plus the sound functionality) or are they more fully featured like the Sapphire snd other manufacturers decoders?yes the same ,the tts offers more control over the motor cv 150-154 and a startup delay cv201 on steam loco's Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.