ron 47 Posted February 11, 2018 Share Posted February 11, 2018 Hi i have the three way point on the diagram and have put a slip point on the diagramwill they point program in to the Elink ok i have Dcc consep decoder. are there any tips for progaming them in thank Ron Link to comment Share on other sites More sharing options...
Chrissaf Posted February 11, 2018 Share Posted February 11, 2018 You need (if you haven't done already) to upgrade RM to the ProPack edition to support 'three way points' and single / double slips../media/tinymce_upload/2c70830bd0b7602db10fab5aafd988ab.jpg.Once you have ProPack installed, then 'three way points' setting up and configuring is explained on pages 87 to 89 in the RM manual, and Single / Double slips on pages 89 to 91. Link to comment Share on other sites More sharing options...
Fishmanoz Posted February 11, 2018 Share Posted February 11, 2018 To program the decoders, you do this by pressing the button on them for programming mode, throw the point/slip element on your schematic that you wish to control, then go back to run mode and it’s done. It’s all explained in the decoder documentation. Link to comment Share on other sites More sharing options...
ron 47 Posted February 12, 2018 Author Share Posted February 12, 2018 Hi Thank you all working fin yep upgrade to the pro pac a long time a go.regards Ron. Link to comment Share on other sites More sharing options...
Chrissaf Posted February 12, 2018 Share Posted February 12, 2018 Glad to hear that you got it sorted with minimal additional help input. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.