TUGMASTER08 Posted June 21, 2011 Share Posted June 21, 2011 Having just 'chipped' an 0-4-0 chassis with Hornby's new 4 function decoder, following all the sections found in the downloads, when put on the rails it runs as expected but if I turn off the power it continues to run until it 'runs out of electric'. I am using an 'Elite' controller. Has anyone else come across this 'grind to a halt' situation and is there a remedy? All comments will be welcomed.Garth Link to comment Share on other sites More sharing options...
poliss Posted June 21, 2011 Share Posted June 21, 2011 If you want it to stop quickly then change the deceleration rate as shown in the Elite manual. Link to comment Share on other sites More sharing options...
81F Posted July 21, 2011 Share Posted July 21, 2011 Does anyone know if the Cledoniam Pug in the current Railroad range is DCC ready and would a Hornby GWR 101 body just clip fit onto it? Link to comment Share on other sites More sharing options...
poliss Posted July 22, 2011 Share Posted July 22, 2011 It's best to start a new thread for a new topic 81f. Link to comment Share on other sites More sharing options...
81F Posted August 3, 2011 Share Posted August 3, 2011 poliss said:It's best to start a new thread for a new topic 81f. Link to comment Share on other sites More sharing options...
The son of Triangman Posted August 4, 2011 Share Posted August 4, 2011 The stretched caley Pug in the Railroad range is not DCC ready, you could fit a Holden 101 class tank loco body to the chassis but you will need to discard the caledonian body and cast footplate/runnning board. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.