Henry tender motor

[tradie]

i am trying to remove the motor out of the tneder chssis of henry so can see the wheel problem, just doesnt seem to want to come out. there is, what looks like, a plastic part going into the chssisabove the tow pin, but i cannot seem to a) remove it b) how it comes out.

Any help please ?

[Modelnut19]

If it is a tender drive then I think you will find the motor section can be carefully prised out of the tender chassis using a screwdriver at each end of the chassis. However, I should check for some guidance on YouTube first.

[tradie]

If it is a tender drive then I think you will find the motor section can be carefully prised out of the tender chassis using a screwdriver at each end of the chassis. However, I should check for some guidance on YouTube first.

 ive looked and its not on you tube or sim it is that clip that goes into the chassis above the tow pin needs to either be moved or taken out im not sure it doesnt want to budge any more prising i will bend the chassis

[Chrissaf]

TIP: As a newbie poster on the forum, just be aware that the 'Blue Button with the White Arrow' is not a 'Reply to this post' button. If you want to reply to any of the posts, scroll down and write your reply in the reply text box at the bottom of the page and click the Green 'Reply' button.

.

See also – further TIPs on how to get the best user experience from this forum.

https://www.hornby.com/uk-en/forum/tips-on-using-the-forum/

.

[96RAF]

You need to prise the arrowed lug away from the tender frame. It is similar at the other end. You may need to remove Items 18 for access to it.

Service sheet 258

/media/tinymce_upload/7158db1a26b858d18393c3979f2a4920.png