Pete1943 Posted April 10, 2012 Share Posted April 10, 2012 Have a lot of problems getting railmaster and the Elite to sync the forward and reverse to match, the elite on its own is fine but the railmaster is wrong, if I say forward the loco goes backward an visa versa, if I set the config in railmaster to reverse control then its out with the elite, it driving me to drink. the loco`s are hornby DCC fitted, so there's no wiring problems. I have updated the elite firmware to 1.4 and railmaster is 1.30, HELP. Link to comment Share on other sites More sharing options...
jimmydick Posted April 12, 2012 Share Posted April 12, 2012 I have the very same problem with one of my loco's. Anyone know the answer?? Link to comment Share on other sites More sharing options...
Pete1943 Posted July 31, 2012 Author Share Posted July 31, 2012 I have updated to the latest 1.40, I await with interest now to see if this problem has been fixed, as horny refused to believe that this was a problem, I don't suppose they have, but will see in a few days. Link to comment Share on other sites More sharing options...
stevecamden Posted July 31, 2012 Share Posted July 31, 2012 What happens if you set the loco to (dir reversed) in the config in the Elite/ page 31? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.