apratihar Posted May 12, 2012 Share Posted May 12, 2012 Dear All,I have 2 points connected to 2 different terminals of Access decoder (R8247). I want these 2 points to be switched together. Please advise, how this can be done by programing through Elite. Link to comment Share on other sites More sharing options...
Flashbang Posted May 12, 2012 Share Posted May 12, 2012 HiThe simplest way is to connect the two motors onto one set of outputs.The accessory point decoder is ok to operate two solenoid motors at once from one output. Link to comment Share on other sites More sharing options...
markSandD Posted May 12, 2012 Share Posted May 12, 2012 I can confirm that this works. I have several 'crossovers' connected in this manner. Link to comment Share on other sites More sharing options...
Fishmanoz Posted May 12, 2012 Share Posted May 12, 2012 Hornby documentation confirms the system is designed to switch 2 at once on the one output. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.