Fishmanoz Posted June 12, 2012 Share Posted June 12, 2012 Eurostar, assuming montywb is right, substitute 1for 0 in my earlier post and see how it goes. Link to comment Share on other sites More sharing options...
Montywb Posted June 13, 2012 Share Posted June 13, 2012 Fishmanoz said:Eurostar, assuming montywb is right, substitute 1for 0 in my earlier post and see how it goes.He is right, lol, that's what it says in the instructions - and I've got one. Link to comment Share on other sites More sharing options...
Fishmanoz Posted June 13, 2012 Share Posted June 13, 2012 So does it work now? Link to comment Share on other sites More sharing options...
Rcik Posted March 14, 2017 Share Posted March 14, 2017 Realise this is an old thread but I purchased a 1960 Brighton Belle a couple of weeks ago ( dcc ready, not fitted). Coach lights worked fine on dc but didn't work when I fitted a chip. After a few hours fiddling with dcc chip settings and the connector between the two coaches, I finally searched on the web and found a suggestion that some of the dcc connector boards on the model have been wired incorrectly so pin 1 is labelled wrong. Reversed the chip and lights now come on and off with F1 as they should . Loco ran backwards but a change to cv29 can sort this easily. Just thought I would post if anyone else ever has the same problem. Link to comment Share on other sites More sharing options...
RDS Posted March 14, 2017 Share Posted March 14, 2017 @Rcik That sounds a good tip for anyone with the same problem. Unfortunately, despite Fishy asking directly in June 2012, we don't know if Eurostar127 ever sorted out his problem. (I have tidied this thread up a little, by removing 3 of Eurostar127's posts, where he had merely copied a previous posters comment, without adding anything) Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.