brooks Posted May 8, 2013 Share Posted May 8, 2013 I've set up eight point motors. Using the Elite they all work perfectly. Through Rail master all but two switch the tracks then switch them back. I've checked everything more than once and can't see why this happening. The only thing I haven't tried is as shorter USB cable. Any advice would be appreciated. Link to comment Share on other sites More sharing options...
Fishmanoz Posted May 8, 2013 Share Posted May 8, 2013 Certainly the advice is to use a good quality shielded USB cable connected directly to your computer, not through a hub. Link to comment Share on other sites More sharing options...
brooks Posted May 8, 2013 Author Share Posted May 8, 2013 Fishmanoz said: Certainly the advice is to use a good quality shielded USB cable connected directly to your computer, not through a hub. Link to comment Share on other sites More sharing options...
brooks Posted May 8, 2013 Author Share Posted May 8, 2013 That's the only thing I can think of. I'll try it tomorrow. Thanks. Link to comment Share on other sites More sharing options...
brooks Posted May 9, 2013 Author Share Posted May 9, 2013 Working perfectly now with a new cable but a slightly dysfunctional usb socket on the laptop didn't help. Thanks for advice. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.