cuz Posted November 28, 2013 Share Posted November 28, 2013 I am unable to get the Elite or Railmaster to programme the Gaugemaster accessory decoder, even though it is listed on Railmaster. The decoder LED flashes when either reading or programming but railmaster always displays the message no response from decoder. Both decoders are operating outputs 1-4 and I cannot get either to move up to outputs 5-9. I have tried to change the main CV address code using the Elite without success. Has anyone have a suggestion or solution please, Ian. Link to comment Share on other sites More sharing options...
Fishmanoz Posted November 29, 2013 Share Posted November 29, 2013 Again, email RM support. Link to comment Share on other sites More sharing options...
LMSFan72 Posted October 24, 2015 Share Posted October 24, 2015 Just wondering if anyone ever got further with this. I have the same issue with a DCC30. Railmaster support cannot give specific 3rd party advice Link to comment Share on other sites More sharing options...
Chrissaf Posted October 24, 2015 Share Posted October 24, 2015 In that case then, talk to GM or mail their technical department on technical@gaugemaster.co.uk Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.