pete007 Posted December 26, 2013 Share Posted December 26, 2013 Hi Guys, I have just installed railmaster on to my laptop and have just designed my track plan. I noticed that some of the control makers snapped to the points when I moved one of them and some did not do that and I had to move both red & green marker. The ones that snapped to the point show a grey line on the point to show which way it is set for and the other don't, I have not yet connected to my elite controller yet to see if they all work. But I would of thought all should show the grey line on the point. Anyone had similar problem? Cheers Pete Link to comment Share on other sites More sharing options...
HornbyRailMasterSupport Posted December 26, 2013 Share Posted December 26, 2013 During track design, if you drag either the red or green point control buttons into the centre of a point they must always snap into position. This is detailed in the RailMaster PDF guide under track design. This will then cause all points which have point control buttons to show the blue route indicator lines. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.