7thAge Posted June 8, 2011 Posted June 8, 2011 Please can anyone tell me if it is possible to re- programme R 8247 accessory decoder using a R8213 Digital select controller. I have inadvertently programmed two decoders start address 61. Another senior moment !. Many thanks 7thage.
poliss Posted June 8, 2011 Posted June 8, 2011 I don't know much about the point decoders, but have you tried going through the programming sequence again?-----------------------------Get off the line Bobby.
FinnerZ Posted June 8, 2011 Posted June 8, 2011 I don't see why it should be a problem. Just make sure that only the decoder you want to reprogram is attached when you reprogram.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.