Golden Arrow 462 Posted February 15, 2015 Share Posted February 15, 2015 When points are configured in a crossover design is it possible to throw 2 motors from one port (decoder). I am using E link and don't want to risk derailments if I forget to activate second motor dure to age forgetfulness.Any help will be much appreciated thank you Link to comment Share on other sites More sharing options...
choralc Posted February 15, 2015 Share Posted February 15, 2015 Wire both motors into the one one output and then program which will give both the same address. If one works the opposite of what you want change the +ve and -ve wires around. BTW this would have generated more responses if posted in the Railmaster section as you are using eLink. Perhaps admin will move it after the weekend Link to comment Share on other sites More sharing options...
Fishmanoz Posted February 15, 2015 Share Posted February 15, 2015 For a full coverage of this, go and look in the RM forum at the topic Home > Forum > Hornby RailMaster > How do I make and wire up points to make them move when clicked? The HRMS post on page two gives you alternatives as well. Link to comment Share on other sites More sharing options...
Chrissaf Posted February 15, 2015 Share Posted February 15, 2015 Or go straight to the forum page in question using this. https://www.hornby.com/forum/post/view/topic_id/8669/?p=2 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.