richardp Posted November 10, 2011 Share Posted November 10, 2011 I have a Hornby Elite and railmaster but I cannot seem to get the points to work at all. Nor can i see how to set up 'groups'. I do not have any decoders but just wat to use the controller for now. My points are wired into the auxiliary output - is that correct? Link to comment Share on other sites More sharing options...
poliss Posted November 10, 2011 Share Posted November 10, 2011 No, to use Railmaster to control points you must have accessory decoders. To change points using the Elite without accessory decoders you must use passing contact switches, or similar, as sold by Hornby.You cannot change points by connecting wires from the point motors directly to any controller. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.