gorny Posted February 27, 2018 Share Posted February 27, 2018 Hi I have a hornby elite controller and last night I was operating 2 locos on the one track. Is there a way of rotating the dial to bring up the loco address rather than typing it in all the time to bring the said loco up.ie switching between the two. Any feedback would be greatly appreciated Alan Link to comment Share on other sites More sharing options...
Chrissaf Posted February 27, 2018 Share Posted February 27, 2018 You are doing it wrong. Once you have assigned a loco to controller knob 'one' you then assign the second loco to controller knob 'two'. Then it is an easy task to switch between the two locos by just pressing the appropriate controller knob. If you have previously called up and assigned more than two locos during the same 'play session' then pressing the 'Escape Key' scrolls through all the previously selected loco addresses in its memory for quick selection..Its all explained in the 1.44 Elite manual on pages 18 and 19../media/tinymce_upload/89611d4f13f06da56fa771a8cebd6ba3.jpg.Rule 1, if you don't know how to do something, read the manual. If it is doable, it will most likely be documented in the manual. Link to comment Share on other sites More sharing options...
gorny Posted February 27, 2018 Author Share Posted February 27, 2018 Ok thank you Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.