31550 Posted March 26, 2018 Share Posted March 26, 2018 I am about to remove the body of my H class (31518) to fit a decoder. This requires the remova of four screws. The two at the rear are easily accessible, but those at the front have a cover over them. How is this cover removed?, I cannot find any help about this.thanks Link to comment Share on other sites More sharing options...
31550 Posted March 26, 2018 Author Share Posted March 26, 2018 OK, I’ve sorted it, thanks anyway.Is it possible to delete your own posts? Link to comment Share on other sites More sharing options...
Chrissaf Posted March 26, 2018 Share Posted March 26, 2018 31550.No you cannot delete your own posts. But as Caiptean says, post what you did to remove the cover for the benefit of others. Link to comment Share on other sites More sharing options...
31550 Posted March 26, 2018 Author Share Posted March 26, 2018 It was a little cylinder shaped cover that just prised off easily. Link to comment Share on other sites More sharing options...
Chrissaf Posted March 26, 2018 Share Posted March 26, 2018 Thank you. Link to comment Share on other sites More sharing options...
Derek 19B Posted January 4, 2020 Share Posted January 4, 2020 I know it's a while since the last comment but ! My H class part of the R3512 push pull set does not need anything prising off just the mem Socket removing before accessing the front screw.Its been fine good little runner till it just stopped Boxing Day .Hope it stops someone prising at things that do not need it. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now