dapatter Posted February 8, 2012 Share Posted February 8, 2012 Hi i installed some peco point motors on hornby track with a lenz decoder, all was working fine, with good switching control. now one of the point motors when i fire it in one direction does not properly close the point. I have checked and their are no obstructions on the point itself, any ideas? seems to go halfway and then fall back Link to comment Share on other sites More sharing options...
poliss Posted February 8, 2012 Share Posted February 8, 2012 Check the wiring. Check that the spring hasn't come out of the point. Link to comment Share on other sites More sharing options...
dapatter Posted February 8, 2012 Author Share Posted February 8, 2012 poliss said:Wiring is fine. Spring looks a little bent. Is there anywhere to get replacement springs?Check the wiring. Check that the spring hasn't come out of the point. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.