john_ellis Posted March 7, 2020 Share Posted March 7, 2020 changing a used point decoder back to factory settings is cv8 to 8 i think can i do this on railmaster pro and change the 4 output numbers please Link to comment Share on other sites More sharing options...
Chrissaf Posted March 7, 2020 Share Posted March 7, 2020 Yes,.This previous post explains how to use RailMaster to factory reset a R8247. See my post, 4th one down on the page, but do check out the 'note' I wrote at the end of the post regarding PRO..https://www.hornby.com/uk-en/forum/post/view/topic_id/9065/?p=2.For a complete tutorial on using RM to configure the R8247 port addresses. See this other post of mine [again the 4th post down on the page]..https://www.hornby.com/uk-en/forum/programming-accessory-decoders/?p=1/.. Link to comment Share on other sites More sharing options...
96RAF Posted March 7, 2020 Share Posted March 7, 2020 Yes you can.Go here/media/tinymce_upload/891b32bfbe42768718ff81caf0d56b2a.JPGMake sure your decoder is the only thing connected to the programming track. Type in the first new address and the rest will fill in for you. Adjust the on time as required and then click the pencil icon - bottom left of picture.You can also read an exisiting decoder settings from this screen but sometimes you get odd answers. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now