Sri-355216 Posted May 4, 2022 Share Posted May 4, 2022 Hi,Is it possible to use a isolated section of the power track and a crossing points track from Hornby as a programming track? I have the DCC Select controller and DCC Points Accessory Decoder. Need to program 16 points and don’t want to do it on my running layout. Link to comment Share on other sites More sharing options...
96RAF Posted May 4, 2022 Share Posted May 4, 2022 Just disconnect the layout from the Select and connect a feed from each point decoder in turn to the Select.Once programmed connect the decoders to your track bus, noting that the Select uses point addresses starting at 61. Link to comment Share on other sites More sharing options...
Sri-355216 Posted May 5, 2022 Author Share Posted May 5, 2022 Just disconnect the layout from the Select and connect a feed from each point decoder in turn to the Select.Once programmed connect the decoders to your track bus, noting that the Select uses point addresses starting at 61.Thanks. That helps Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now