gilbo2 Posted August 12, 2013 Share Posted August 12, 2013 I have a number of R8247 accessory decoders which have been working perfectly for many weeks. Out of the blue yesterday one of them needed to have its address re-programmed. Any suggestions on how this might of happened and how I could prevent it in the future? Wiring wise they all come off my 2.5mm "ring bus" and are controlled through RailMaster. I'm hoping this is just a one off event!? Link to comment Share on other sites More sharing options...
Rog RJ Posted August 12, 2013 Share Posted August 12, 2013 It sometimes happens if there has been a short circuit on the track. Link to comment Share on other sites More sharing options...
gilbo2 Posted August 23, 2013 Author Share Posted August 23, 2013 Rog (RJ) said: It sometimes happens if there has been a short circuit on the track. Thanks Rog, since watching out for shorts I've been ok since. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.