grumpyoldman

Hi All Have just fitted a Hornby sound chip to my Black 5, lasted two days flames and smoke from tender. Now no sound or drive. Fitted spare 4 pin encoder to loco, drives fine now. Brought from Hornby last week. Will contact Horndy tomorrow to hear what they have to say.

Thanks Chris will do.

Hi can anyone tell me if you can do a master reset deleting all the locomotives on the rail master software. Have done a reset on the elite controller and want to do a master reset now on the railmaster so I can start afresh with a clean system to renumber all my loco Id addresses. looked in the railmaster Manuel but could not find any information. Thanks Ian

Hi All Have called Hornby yesterday but they could not help as the screw has no part number on the serves sheet, so it's not a spares item. Poor show IMOP not like the old Margate days when all parts had a part number. Will resort to tapping out to 1.5mm and fit my own screw and solver my problem that way. Thanks you all for your advise. Ian

Yes all ready on to it. Better late than never.

Hi Do's anybody know the screw size for the body fixing screw on a Britannia (R2719X) spares sheet SS289D, or where to get one. Tryed Peter's Spares but they cannot identify the screw as there is no part number on the spares sheet. Put the screw up while fitting a sound decoder and now cannot find it ! ☹️

Thanks Chrissaf for your prompt reply. I was just coming round to the idea of giving it a new address, it makes sense as I have added some more dcc point and accessory switches. Will write the addresses down this time learnt my lesson should have known better at my age. 😳

Help can't find my turn table on Elite controller. I have not used layout for 5-6 years. Is there a way to search the address data base to find it's address? 😢 Relaying and rewireing layout. TT decoder wired up to bus bar and input rail to TT driving Loco,s. Would appreciate help to sort out problem.