Hi All
Does any one have any experience of fitting a DCC chip to a VEP unit DC
My NSE VEP on DC analogue control was very good with non of the poor running experienced by others
I am using a NCE Powercab controller, Hornby NSE VEP
and Bachmann 36-553 DCC decoder (with back emf)
I have fitted the chip - all ok, but the powercar will not run properly on DCC.
Do I need to connect all 4 cars together again?
At the moment on speed setting 1 it shoots off in an extremely
jerky manner, and not calming down until speed setting 3 - it is then controllable.
Does any one have any ideas please?
Cheers
Andy
