adrian_norman

Good Morning, I'm afraid we do not have any Instruction Leaflets from 1983. However, the red rectangular plug with two copper contacts plugs into the underside of the track. One on each lane. The wires from these plugs go to the hand controllers and powerbase. These are hard-wired so nothing needs doing here. On the underside of a straight track piece, about 1 foot long (350mm), you should find a moulded stamp of C160. On each lane you'll find a receiving rectangle for the red plug. Push the red plug in to this moulded rectangle and the two copper pins will nestle against the metal track rails. With the power turned on, put a car on the track and pull the trigger. The car might move backwards, in which case you should turn the car round or turn the red plug 180 degrees as per your 'direction of travel' preference. One more thing, if you have lane change crossovers (not crossroads) always use these in pairs to make sure that a car on a lane can cross over to the other side of the track and then cross back again! I hope this helps. Happy Racing :)