Milkman rob

Is problems with the digital Chip common? I have converted a few cars that’s have gone wrong almost straight away, they’re not exactly cheap to keep replacing

These are the new minis that you are producing now but based on the original 1960s mini, gear on these cars is much smaller than regular cars due to the size of the car itself

I have a mini c3747, and the rear gear on the axel is missing teeth, I can't find anywhere to buy a replacemen?

Thanks for your reply, I did manage to get the piece of track off I opened it up underneath and yes a small wire had come out of the flipper, fiddly to put back in but at least I found the problem thank you

thanks for your reply, I think the problem is with the straight lane change, the lane change is right next to the power supply and on a long straigh, I have about 20+ digital cars and all the same result, since first post I've noticed when the flipper is in the straight position it will flip open when triggered but it will not flip back after any car passes back over it also the flipper sometimes sits in the middle, any ideas for the track or is it knackered

One of the flippers on my straight lane change, changes by itself or if it does change on the button it doesn't flip back, any ideas. As it's on a fully detailed circuit it's not very easy to change without disturbing a large area

I found the easiest way around the track shorting out was to undo the long base plate underneath and remove the copper tape from the outer 2 rails, there is no need for this and now it works fine