Good Morning All, I thinking of creating a layout 18x3 but ideally would like it to be a continous run/loop? Anyone have any ideas how I could creat a loop/continuous loop on a 3ft wide board?
So my boards are going to be 6ftx2.5ft So going to use a 12mm hardwood ply top, with 18mm x 44mm timber. with 4 study legs. Do you think the timber dimensions is adequite?
Hi All, About the build 4 x 6x2 baseboards, going to use a 3x1 timber frame and 12mm ply, question is though, why not mdf and what is recommended soft or hard plywood?? Thanks Carl
Hi All, Been searching for a while as I have lost the NEM sockets for the Hornby Class 60 DCC I own. Can anypoint point me at what I am looking for please. Looked all over the Hornby website. Carl
So I have around 10 locos, 4 are dcc and 6 are DC. They don't run together. But I'm looking for a dc controller to use for the 6 locos. Any suggestion for my requirements?
Hi there, so with my layout I have a dcc feed for the main lines and one dcc feed for the sidings. Issue I have is I would like to get a connector that converts 4 wires to 2 so that I can connect 2 wires to the controllers instead of 4. Any ideas what that would be?
Hi there, Looking for some input on Point locations. If you look at the below picture I have set out two possible layouts that I could do, I liking the left option as it would give locos the chance to go from the fair right side of the track to the innner side without having to go round again and again....What do you all think? /media/tinymce_upload/af6e082f03a4ff735b0caac92e4be5cd.png Carl