DonT

I have set up the hm 7000 8pin sound decoder on Bluetooth. Using e/link, my query is if I want to use the decoder on DCC through the RM /elink , do you set up the decoder as normal. I want to confirm as I do not want damage the decoder.

After down loading version 1.74 have found one loco(Flying Scotsman )will not move until throttled is at 19kph

Gentlemen, It appears I have put a few members offside which was not my attention and apologies to RAF 96. With regard to my query RDS post 4018 has answer my question. I carried out a check and came up with same result as RDS . With regard to the y tube link I tried several times to attach with no success.

Gentlemen , One more time I viewed a video regarding setting points and ligths/signals on the railmaster track plan and it was mentioned that the lights /signals would stop locomotives, even though there was no decoder or actual lights/signals wired to railmaster. My query was if this true how does it stop the locomotivesas I could no see how. Just to me clear I do have a decoder controlling my points. Norman Q 4 to answer your question"Aussie Explanation " was a joke.

RAF 96 It is obvious that you have trouble with my Aussie explanations. Your reply is aggorant and look winded, if you read my message that I am talking about the lights that STOP the locomotives and not having to have lights on the actual track or a decoder connecting to railmaster, a simple NO would have been sufficient.

No. It appears the last part of message was deleted . As I have stated the points are ok the issue is the lights they have been added to the plan but at present I am unable to purchase an additional decoder or lights. I have watched a video regarding setting up points and lights and it was stated that ligths (on the plan) can stop the loco without having ligths or decoder connected to railmaster. If this is true and if so how does it work.

Sorry I have not replied to my problem tried all the suggestion without out success .Finally work out the problem HUMAN ERROR. Very small error I was clicking the X on the overwrite pull down. If that makes sense ,have set up new track plan. I have another query,have set my point motors and working ok.also inserted lights for the points on the plan . At present unable to purchase another decoder or lights (budget restrictions

Ok I realise that I have not explained the problem adequately,but hear goes 1. I had to change my original ' track design' as 2 green/ red point buttons were not positioned correctly. 2. The changes were made and I tick the green tick then the overwrite. I went back into the track designer and there was no schematic showing 3. I researched and found that the file name should have been changed which I changed.Went back into the track designer and still no schematic. 4. 'The Track Syatem was showing my original file name 'Turner Railway Track 2'.which was to the the new name but still no schematic. The bottom line is that the schematic will not come up on the' track designer'. Though the sample and hornby schematics come up. I know this is a little long winded but hope you can make sense of it and will stay with 1.67 as I did not want to get into more trouble and appreciate your prompt response regards Don