pixvalley

1. My IPOD Mini was to old the run the apple app 2. I never used any android app 3. I have an issue with one of my Hornby locos with a TTs chip the runs away if address 3 is selected. 4. I ran the TXS chip on the rig out of the box having removed the above loco of the track it ran ok. 5. The problem arose when I changed the address from 3 to 821 all appeared okay. 6. When I tried to read the chip CV’s back no response from the chip. 7. This is what I reported over the phone and got the weird reply about reset codes etc. 8. Let put this post to bed now Its gone back to Margate Mod note - locked as requested.

I didn't know there were two types of decider

HM6K Android app what's that?

I spoke with a Product Development Engineer via email and i was suggested that it is sent back for testing and a flash upgrade? on way back to Margate now

It gets better! Delivery has failed to these recipients or groups: customerservices.uk@hornby Your message wasn't delivered because the recipient's mailbox is undergoing maintenance and can't accept messages now. Please try resending the message later.

I have just got off the phone to Hornby support on 01843233525; apparently I can’t access the decoder until the android app is released. He also told me they don’t know when the android app will be released so there is not a lot you can do with the decoder until then. Apparently the decoder is locked and I require a device reset passcode which will be sent when I Pair the decoder to the android app! Um I can smell bull****.

I cannot read any cv from the chip using the Gaugemaster prodigy and ESU test rig its not fitted to a loco yet so dirty wheels or pickups aren't an issue. I. contact Hornby today because this is a massive issue for me.

I have android so I cannot use bluetooth yet I just wanted to reset loco address from default to 821uing my programming output on the Gaugemaster prodigy. Fed up waiting for the app

Its an 8-pin

No response from HM-7000TXS. I plugged the decoder into a ESU test rig to check the function of the chip before fitting it to the loco. I cannot read the address with my Gaugemaster prodigy before I reset it to the loco number. I tried to reset sending value 8 to CV8 still can’t read the chip. Any ideas?

When I programmed my Class 66 TTS chip testing it in an ESU rig at default address 3. My TTS Mallard creeps away and will not respond to the handset. Gaugemaster prodigy advance 2 Loco manufacturer Hornby Chip manufacturer Hornby TTS Locomotive Mallard CV 1 Loco 4468 CV 2 Start Voltage 0 CV 3 Acc Momentum 15 CV 4 Dec Momentum 15 CV 5 Top Voltage 0 CV 6 M Voltage 0 CV 7 Decoder Version 14 CV 8 Manufacturer 48 CV 17 209 CV 18 116 CV29 addressing 34 CV29 reverse direction no