Lynrob

Thank you very much for your help Ethan and P-Henny Till next time Stay safe regards Lynrob

Thank you for all your help 96RAF it is appreciated. Till next time stay safe Regards Lynrob

Thanks again everyone. This morning I connected the Point decoder to the programming track and once more went through the instructions on page 1 of the leaflet that came with the decoder for the I do not know how many times, set it back on to the main track and walah it worked, could not believe it. Will now try to name that number 1 turnout. Thank you so much for all your help, take care regards Lynrob

Hi All thanks for the replies to my problems have tried the car light bulb test and getting power to the Point Decoder R8243 but no power coming out of the connection number 1 when operated with the Hornby Elite. So guessing there is a programming problem, will try to work thaytm out over the weekend, havent been feeling the best so not been doing much to the track. Hope you all have a good weekend Regards Lynrob

Thanks every one. Have used the car light bulb test and no power there is no noise at the motor so its a programming problem. Will start again from scratch, all the wires are connected and using a programming track and trying to follow the help everyone has given me and the instruction book and updated instructions from Hornby. Think as we get older this digital stuff is more difficult, my first train was wind up, it marvellous to have a train that sounds like a train and whistles as well, even a Vent Van that sends out the sounds of many things, fantastic. Will keep trying Regards Lynrob

Hi am using Hornby Elite R8214, and a Point and Accessory Decoder R8247 and Point motor R8243 and unfortunately its not working I have checked the connections and all ok, do I have the Red Black and Green cables from the Point motor connected right. Green to - . Black to c. Red to +. If anyone can help would be greatfull, or any thing you can sujest apart from thowing it all out the window. Thank you Regards Lynrob

Thank yopu very much for yuor help with the problem i am having. Best wishes Regards Robin

Thank yopu very much for yuor help with the problem i am having. Best wishes Regards Robin

Thank yopu very much for yuor help with the problem i am having. Best wishes Regards Robin

I have 5 turnouts so will have 2 Points decoders (R8247). From the info you gave me guess program the second decoder 2. Thank you very much for that, Regardss Robin

Sorry forgot to include controller, using Hornby Elite

Hi I am having a problem with programming a Hornby Point and Accessory Decoder R8247 also the point motor R8243 surface mounted. Think I have too much information and getting a bit confused with everything can anyone help with some easy to follow advise Thank you.

Thank you all very much I was looking at R603 rails and couldn't work it out. Have a R600 track and found tge slots, easy when you know how pitty it's not explained in the instructions on line. Never mind problem solved thanks everyone Regards Robin

Good afternoon I have purchased two Hornby accessory decoders to ooerate the five turnouts I have on the layout and am having trouble fitting the DCC power from track clip to Hornby rails without cutting the black plastic sleepers, any one fitted one of these. On the website it said fit into the two slots on rails, there aren't any slots in the Hornby rails I have, would appreciate any help anyone can give Regards Robin