Andrew-1210417

I have found out why the sound was not coming through. With silent mode on my phone will stop messages and calls being audible but will allow apps to function as normal. However the app for HM DC requires silent mode off to work on my iPhone XR.

The sounds is on and working for the instruction videos. The connection is working so I can operate the train. I am using mesh and low frequency. The issue is that none of the sounds for steam, electric or diesel are Audible the UI registers the request but does not output any audible associated to the button that is pressed. i have also tried both channels and both connection types as well as reinstalling the app.

i have picked up a Hm 6000 but I am having issues with the sound not coming through to my phone. I am using an iPhone Xr and do not have any issues with other apps. Has anyone else had the same issue ?

Thank you all for your help

I am currently running the small 4 wheel coaches on my 1st radius setup but I want to run one of the railroad Pullman coaches. Does anyone know how these coaches run on 1st radius?

i was running a 2nd hand Bachman 060 however I was getting an issue with the inside drive wheel becoming loose. Not sure if it was caused by 1st radius or just because it is old

Thank you all for your advice on this

i currently have a small 5ft by 3ft layout and I want to runs some different loco’s. looking on the hornby site 73965 works on 1st radius and 73964 shows as a minimum of 2nd radius. Looking at the images both loco’s look identical. Does any one know what the differences is between them to enable 73965 to run on 1st radius?

Thank you very much I really appreciate your help

I am new to all this and I am currently putting together A small layout. I have a couple of tracks coming off of a point where I have two platforms. Both platforms will become the same length once I have finished. However will the bridge fit across both? Or is the bridge made for track parallel where two points are used for an inner and outer track?