Good Evening I recently installed railmaster and a elink to a laptop, I have started to set up my locomotives to the system this evening, but found an issue with my dcc fitted Clan Line from the R1073 Set, I have previously run the locomotive with a hornby select with no issues, the locomotive runs fine with railmaster, but the speed is either 0 or 1, I have set this up with the loco part number, it gives me the cruise and shunt speed on the set up, but only get off and on, and no graduations inbetween I have set up my railroad 9f and get the speed steps on the controller and what scale speed it is running at, so I assume the control for Clan Line should be the same Any help to resolve this would be appreciated Regards Stuart
