Connor-350963

Update: I after some fiddling it seems like the motors will easily push the points back into the straight position but won’t pull them back into the curved position. This never happened when I had the original power. Some of the points that aren’t on the raised roadbed will work both ways just fine but others won’t. I must say I’m getting frustrated. I don’t want to have to rip everything up and replace it with hornby switches because it’s not easy to get here.

I am running OO points. It’s an OO layout with peco points and peco point motors. I live in Canada so that’s what’s readily available. Getting actual Hornby track and points is a little difficult

I’ve made sure all the motors are aligned but still nothing. They work just fine without being connected to the points. Are the peco points just too heavy for the modules to move? They motors worked just fine with I had them installed on switches connected to a regular dc power pack but I want the app control.

Hello there, I have just finished setting up my Hm 6010 on my small layout. I have 3 of these modules for 12 points and they are all peco points controlled by P-11 motors. The issue is I can hear powering going to the point motors but they just twitch and don't fully move. I want my entire layout to be app controlled and this is perplexing me. I have the wires in the module correctly (I know that peco and hornby reverse which wire colour is common) so I’m all out of ideas. Any help would be greatly appreciated.