Mark-353500

Hi can some one please put me in the right direction for installing cab lights I have two wires one positive and ones negative so I am thinking live to aux 1 when I find out what pin it is an negative to either ground PIN number I am not sure of or common pin 16 blue wire. if someone can point me in the right direction it will be a great help Thanks mark

Hi just customerCare@hornby.com

HI yes I have thanks I have it all sorted now see my other post about how support didn't help very much https://uk.hornby.com/community/forum/hornby-support-are-not-that-good-with-these-decoders-353678?ccm_paging_p=1#end-of-replies

ragerage Rant time!!! I have just spent 2 or 3 days in an email conversation with Hornby support about my HM7000-21TXS, and to be honest I think I solved my problems with out any help from support as they didn't seem to appear to know too much about there decoders. They asked me to confirm the same thing several times and repeated the same question along with directing me to the manufacture of my DCC system to see if it was my system at fault but of coarse it wasn't I think they were just hoping it was so they could past the blame. If you have a problem with you new TXS decoders can I suggest that in the first instance you try resetting the decoder and starting again just like you would turn a computer on and off it worked for me but they never suggested this. So I am not impressed with this to say the leastragerage

Hi I have just installed my new 21 pin HM7000 decoder in my Hornby class 66 although I am very impressed with the bluetooth side of things although the speaker need to be better. so I tried to control my train with my Digitrax DT602 controller I am assuming I have done everything right seeing that dcc as bluetooth switch of and says edit settings. any advice would be grateful Thanks