john_goodwin1 Posted August 3, 2019 Share Posted August 3, 2019 Hi, i have a number of pieces of peco settrack points which i would like to be able to use with my dcc controlled hornby layout. Can I use the hornby point clips on the peco points to make them live. Many thanks Jacko Link to comment Share on other sites More sharing options...
96RAF Posted August 3, 2019 Share Posted August 3, 2019 Probably but do not expect these clips to pass a considerable load as they are designed for powering a siding or two, not a new loop feeding a fiddle yard, etc. Link to comment Share on other sites More sharing options...
john_goodwin1 Posted August 5, 2019 Author Share Posted August 5, 2019 so if just using hornby points should i be running a bus wire and use droppers for power? Link to comment Share on other sites More sharing options...
Chrissaf Posted August 5, 2019 Share Posted August 5, 2019 That would be my personal preference and just relegate all the track joiners to just performing the function of track joining and physical alignment. Track joiners just like DCC point clips are a potential fault liability. Link to comment Share on other sites More sharing options...
john_goodwin1 Posted August 6, 2019 Author Share Posted August 6, 2019 Many thanks Chris, most helpfulRegardsJacko Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.