Creeping loco

[pixvalley]

When I programmed my Class 66 TTS chip testing it in an ESU rig at default address 3. My TTS Mallard creeps away and will not respond to the handset.

Gaugemaster prodigy advance 2

 

Loco manufacturer          Hornby

Chip manufacturer          Hornby TTS        

Locomotive                      Mallard

CV 1 Loco                        4468      

CV 2 Start Voltage            0             

CV 3 Acc Momentum     15          

CV 4 Dec Momentum     15          

CV 5 Top Voltage              0             

CV 6 M Voltage                 0             

CV 7 Decoder Version    14          

CV 8 Manufacturer          48          

CV 17                                209        

CV 18                                116        

CV29 addressing               34          

CV29 reverse direction  no

[STG]

Presumably, you used the test rig in programming track mode, and with the rest of the layout disconnected, or used it as programming on the main.

Else, you might find the two locos have been programmed onto the same address.

If possible, try a factory reset of the decoders at fault.

[96RAF]

Possible casue is due to DC running being ensbled which it is not on your Mallard.

Can you check you do not have the PA2 set for loco zero. Is so disable it.