grumpy old man Posted May 20, 2012 Share Posted May 20, 2012 HiI may purchase the above ready DCC Loco but not sure what decoder will fit it I think an 8 pin but can any body confirm & if they can also direct me to a site that will give me instructions how to fit the decoder.Thanx Link to comment Share on other sites More sharing options...
Gregd99 Posted May 20, 2012 Share Posted May 20, 2012 I have one of these locos with an 8245 fitted. an 8249 would also be fine.there is an 8 pin socket and a lot of room inside the loco.To remove the body you need to ease out the buffers at both ends. I was not able to do this an had to cut through the buffer stalk using a Stanley knife.I am not aware of a site that shows the installation in a hornby class 20. Link to comment Share on other sites More sharing options...
poliss Posted May 20, 2012 Share Posted May 20, 2012 A well known shop website says it has an 8 pin socket. See Hornby's Locomotive Maintenance sheets for the Class 20. https://www.hornby.com/downloads/locomotive-maintenance-sheets/?page=3 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.