wagonmaster Posted August 15, 2023 Share Posted August 15, 2023 changing loci id setting must have pressed something wrong and now put loco on rails and it charges off at top speed control barely turn on any clues Link to comment Share on other sites More sharing options...
Fishmanoz Posted August 15, 2023 Share Posted August 15, 2023 Sounds like DC Runaway. Check CV29 value for change after ID change and turn off DC Running. Link to comment Share on other sites More sharing options...
P-Henny Posted August 15, 2023 Share Posted August 15, 2023 What controller are you using?You may have accidently put it into Address Zero DC Analogue mode. Link to comment Share on other sites More sharing options...
wagonmaster Posted August 15, 2023 Author Share Posted August 15, 2023 hornby elite controller and i think you may be right about dc mode Link to comment Share on other sites More sharing options...
ColinB Posted August 16, 2023 Share Posted August 16, 2023 What make of decoder are you using? It seems weird that you change something and it does this. There are some decoders that are more prone to DC runaway but it seems a bit weird that it was working OK then it started doing this. I am pretty sure the Elite sets this bit automatically when you set the address. I suggest you program it again. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now