Seacommander Posted December 17, 2023 Share Posted December 17, 2023 Just wondering if somebody on the forum can expand on what appears to be an error message (please see photo) displayed when powering up one of my Elites in diagnostic mode. Link to comment Share on other sites More sharing options...
96RAF Posted December 18, 2023 Share Posted December 18, 2023 What firmware revision is it at. See also Elite start up problem in the other post. It means it sees an error in the memory. Try a unit reset as suggested in the other post. Link to comment Share on other sites More sharing options...
Seacommander Posted December 18, 2023 Author Share Posted December 18, 2023 Thank you for your reply 96RAF. Just minutes after I posted yesterday evening I remembered about doing a factory reset. It worked - all is well - but could not retrieve my post to delete or amend it as it had gone to the mods for approval of the photo.The unit in question is old - I updated the firmware from 1.1 to 1.45 about 4 days ago and just as a check ran the diagnostics. I find it interesting, however, that after updating to 1.45 an error was detected. I somehow imagined that updating might have incorporated some form of reset.Anyway, thanks again for your interest. Link to comment Share on other sites More sharing options...
96RAF Posted December 19, 2023 Share Posted December 19, 2023 Hornby say they have seen the error before, but very rarely.A unit reset always sorts it out. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now