NCFC_Cam Posted September 2, 2013 Share Posted September 2, 2013 My HORNBY digital controller keeps crashing! :( When I change 2 sets of points (which link an outside track to an inside track) the controller will flash "11" . Is there any solution to solving this? Link to comment Share on other sites More sharing options...
NCFC_Cam Posted September 2, 2013 Author Share Posted September 2, 2013 DCC clips Link to comment Share on other sites More sharing options...
Fishmanoz Posted September 2, 2013 Share Posted September 2, 2013 Have you accidentally made a reversing loop? Easy to tell - is it possible to have a loco leave from any part of your track and end up coming back to that same piece of track travelling in the opposite direction to when it left? Link to comment Share on other sites More sharing options...
poliss Posted September 2, 2013 Share Posted September 2, 2013 See the Reversing Loop section on Brian Lambert's website. http://www.brian-lambert.co.uk/DCC.htm#Reversing Loops. Link to comment Share on other sites More sharing options...
RDS Posted September 6, 2013 Share Posted September 6, 2013 @NCFC_Cam Have you sorted this out yet? If not, is it wired so that you have power going to both the inner and outer loops separately. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.