Yelrow Posted August 21, 2014 Share Posted August 21, 2014 hi, have one square on my track plan schematic, that defies all efforts to delete. It will accept another piece of track over the top, but will not delete. Has anybody else had this, curious, john Link to comment Share on other sites More sharing options...
RB51 Posted August 21, 2014 Share Posted August 21, 2014 Sometimes it is possible to put the same piece of track down several times and perfectly overlay the one underneath. You are maybe deleting the top one but leaveing the one below. Try moving it and see if you can delete it. R- Link to comment Share on other sites More sharing options...
Fishmanoz Posted August 21, 2014 Share Posted August 21, 2014 You may have put 3 or 4 pieces in the same spot. If so, you'll have to move/delete them all. Eventually you'll get rid of them. Link to comment Share on other sites More sharing options...
Yelrow Posted August 22, 2014 Author Share Posted August 22, 2014 Thanks guys, it is only the one square, the original track will not delete. Played that game where you go round every square, and it is the only one that simply does not work. Not a problem, as piece goes over the top, but intriging. john Link to comment Share on other sites More sharing options...
RB51 Posted August 22, 2014 Share Posted August 22, 2014 I expect you have tried this, but it is worth saying. Does it remain stubborn if you save the plan come out and go back in again? I sometimes get strange things happen when in planing mode that seem to sort themselves when I go through this routine. Apologies if youhave done this already. R- Link to comment Share on other sites More sharing options...
St1ngr4y Posted August 22, 2014 Share Posted August 22, 2014 Hi John,What happens if you drag the piece to another cell on the grid?What shape track piece is it?Ray Link to comment Share on other sites More sharing options...
Yelrow Posted August 22, 2014 Author Share Posted August 22, 2014 Hi, Ray, horizontal line. Have not tried dragging it, only deleting it, will report back, john Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.