SimoneM Posted March 5, 2015 Share Posted March 5, 2015 Hi,i have some problems with decoder uhlenbrock, lights doesn't work.can u help me? thanks.SimoneM Link to comment Share on other sites More sharing options...
Chrissaf Posted March 5, 2015 Share Posted March 5, 2015 Simone By lights, do you mean the directional lights, if you do then make sure Bit 1 in CV29 is set to ON (28/128 speed steps enabled). See http://www.2mm.org.uk/articles/cv29%20calculator.htm If you don't mean the directional lights, then what lights DO you mean? Link to comment Share on other sites More sharing options...
96RAF Posted March 5, 2015 Share Posted March 5, 2015 To get a half-reasonable answer to a question you could give more information, like which loco the decoder is fitted to, which controller and/or software system are you using, etc. These clues all help towards giving a better answer to your problem. Link to comment Share on other sites More sharing options...
poliss Posted March 5, 2015 Share Posted March 5, 2015 Uhlenbrock make many decoders. Have you read the decoder manual? Link to comment Share on other sites More sharing options...
Fishmanoz Posted March 5, 2015 Share Posted March 5, 2015 And Simone, while you are answering those pesky questions, welcome to the forums! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.