JemBo Posted March 29 Share Posted March 29 Morning all yes I’m a newbie and therefore still getting to grips with the wiring and points etc. Having completed the wiring stage I’m now fitting points - Peco PL10s and whilst I’ve successfully got Port 1 successfully programmed with 61 input I can’t then program the others - ie ports 2,3 and 4. Or 62,63,64 it’s driving me nuts 🥜! can someone please help !!! I’d be so grateful Link to comment Share on other sites More sharing options...
96RAF Posted March 29 Share Posted March 29 The other 3 ports program automatically in sequence. Link to comment Share on other sites More sharing options...
JemBo Posted March 29 Author Share Posted March 29 Thanks very much - this might just be the one nugget of info that cracks this for me Link to comment Share on other sites More sharing options...
JemBo Posted March 29 Author Share Posted March 29 Again thanks 🙏 i tried that on another module and it all works - the first one just didn’t so there we go ! Link to comment Share on other sites More sharing options...
96RAF Posted March 30 Share Posted March 30 13 hours ago, JemBo said: Again thanks 🙏 i tried that on another module and it all works - the first one just didn’t so there we go ! OK so try a reset of the dodgy module by writing value 8 to CV8 just like a loco decoder. This will put the address back to Group 1 (port addresses 1 to 4). Then try to readdress it to within Select accessory range 61 to 99. I.e port 1 to 61 or 65 or 69 or 73, etc. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now