Arc Pro PB LED Board

[MashaFX]

I have 2 LED's out on my ARC PRO, everything else works fine. When turning on, the LED for power and for the LED for the white button doesn't illuminate.

Where can I get the replacement LED board?

Thank you

[Andy P.]

Very odd...

Are you sure it is just the LEDs that are not turning on and there are no other issues?

[Paul -372491]

My lights are on dim or not at all. Have some issues at times programing a car. But all that are programed run just fine and that is 200 +cars. Issue arises if I by a new car or loose the id in a bad crash or short. I have disconnected the unit and reconnected I have power jumps to properly supply power around the track. So not knowing what I have missed.

[Andy P.]

How big is your track?

I have successfully run a 30 meter (100 foot) layout and 6 cars with the two standard power packs and no jumper cables.

You could be getting cross talk from the jumpers...

[Dr_C]

Hi Paul,

There is a FFC style ribbon cable which connects the LED/button panel to the main circuit board. If some LEDs and buttons are not working, most likely this cable is not seated correctly. There are surface mount sockets at both ends.

If you have electronics repair skills you could open up the powerbase and re-seat the cable at both ends. Note there are release tabs on each socket.

If you don’t have the necessary skills or if it’s still in warranty, a return to Hornby for repair would make sense.

Hope that helps.

c