Dodge1965 Posted April 14, 2023 Share Posted April 14, 2023 I have a Hornby P9300 power supply and plan to use it to power the track with the HMDCC App.. The R7324 cable, comes with the two pin plug on the end, to save me ordering a cable and cutting the plug off, as i plan to solder the wires to the track.Has anyone found a connector i can use for wiring this up? I'm sure it was mentioned on another post, but my search skills are crap..Hope that all makes sense, wasn't sure where to put this? Mods is this right place? Link to comment Share on other sites More sharing options...
96RAF Posted April 14, 2023 Share Posted April 14, 2023 Plug the twin pin plug into a choc bloc and wire that to the track. That way your adapter cable remains intact. Link to comment Share on other sites More sharing options...
Dodge1965 Posted April 14, 2023 Author Share Posted April 14, 2023 Rob,I do think that was mentioned before, but my memory is so bad, plus i wasn't looking for one then.. thanks so much, that is a perfect solution and save me butchering the cable..Dodge... Link to comment Share on other sites More sharing options...
96RAF Posted April 14, 2023 Share Posted April 14, 2023 The forum search capability is dire. You can often get a better response by googling the same question which usually gives a direct link to the associated forum post.As they say JFGI. Link to comment Share on other sites More sharing options...
Dodge1965 Posted April 14, 2023 Author Share Posted April 14, 2023 Haha... Didn't know to try google.. Will next time.. love the JFGI..Cable ordered .. Just futted decoder to BB and the remove part, bits fell of it.. Hope i won't need it again !! Link to comment Share on other sites More sharing options...
P-Henny Posted April 14, 2023 Share Posted April 14, 2023 P.S. If you use Google's 'Advanced' search page (see link), then half way down is a 'Site : Domain' field. Put "hornby.com" in that field and Google WILL ONLY search the Hornby.com site.https://www.google.co.uk/advanced_search?hl=en Link to comment Share on other sites More sharing options...
Dodge1965 Posted April 14, 2023 Author Share Posted April 14, 2023 Thanks very much.. Paul.. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now