Jump to content

jane1707819582

Members
 View Profile  See their activity

  • Posts

    416

  • Joined

  • Last visited

 Content Type 

Everything posted by jane1707819582

  1. jane1707819582
    Adm turntables. Metalsmith The arduino system lends itself to this.
  2. jane1707819582
    Track current total .
  3. jane1707819582
    Most likely the motor .DCC is probably over volting the windings look at fitting a dropper diode .
  4. jane1707819582
    Appendix a on the nmra website
  5. jane1707819582
    The wiring does appear correct .so what rating are the bulbs .the decoder can only handle 100 ma
  6. jane1707819582
    Just the opposite tony .mine pulls really well . I suggest running the loco in for a while .if no improvement send it back .
  7. jane1707819582
    Programmable pulse duration,number of pulses per port.Channel Grouping for multiple point control.And 3 address modes. Basically
  8. jane1707819582
    Are you using the autoswitch for a programme track ? If so do either a decoder reset or an unlock .
  9. jane1707819582
    Yes you would notice the difference..
  10. jane1707819582
    Hornsby point enable isolation of the siding and you should not need irj's.
  11. jane1707819582
    Hardboard ,dimply side down
  12. jane1707819582
    It would be worth considering .If your elite went doo dah then your select will still give you a usable controller
  13. jane1707819582
    Try resetting the decoder .8 to CV 8 .if to no avail send the decoder back to your supplier.
  14. jane1707819582
    Try contacting the basset lowke society .they may know someone.
  15. jane1707819582
    From memory zero 1were just 3 wires
  16. jane1707819582
    You may need the very latest firmware on your select
  17. jane1707819582
    Your decoder could beinerpratati gthe signal as DC .disable DC running in cv 29 find the value and take 4 off
  18. jane1707819582
    10 on hornby's current website in various liveries. Some are out of stock via hornby itself .
  19. jane1707819582
    From what you are describing you could well be overloading your select.a CDU gives the point the oomph to change whilst charging itself at a steady rate .so could improve matters .
  20. jane1707819582
    thank you for your help. what would I cut the track with. What glue would you suggest I use? Personnaly I would use a purpose trackcutter like a xuron ,some use a dremel , I would suggest pinning the track with again purpose trackpins, With the xuron ensure you get the ones which cut vertically .
  21. jane1707819582
    Swapping the decoder would be my next step
  22. jane1707819582
    Where the track has lifted is there a track joint .if so split the track and cut a couple of millimetres of and refit the track joiners leave a small gap between the track ends .this can give you the clackety clack of rolling stock passing the joint .
  23. jane1707819582
    Give the pickups a good clean cannot help with the ELITE much other than try the different programming modes you can with the ELITE.Try to reset the decoder 8 to CV 8
  24. jane1707819582
    Give the pick ups and the wheel back faces a good clean .
  25. jane1707819582
    Could be the decoder shutting down because it is overloaded give the motor a service if this no good change the decoder to a larger current capacity .
×
×
  • Create New...